2010 Peugeot 107

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Exhaust system insecure (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill area (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust mounting defective (6.1.2 (a))

Offside Rear Parking (secondary brake) grabbing slightly (1.3.1 (c))

corrosion to outer sill ,underside and components

Offside Front Macpherson strut corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear coil spring insecure

eye level brake light 50% inop

Brake lever has insufficient reserve travel (1.1.2 (a))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Offside Front Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear coil spring insecure

eye level brake light 50% inop

Rear bumper damaged

hand brake travel

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Rear Outer Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Outer Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Items removed from driver's view prior to test phone holder

Rear bumper damaged

Offside Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Rear Bumper mountings corroded but not likely to become detached slight damage (6.1.4 (a) (i))

Nearside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Bumper mountings corroded but not likely to become detached slight damage (6.1.4 (a) (i))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm 155/65/14 (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Items removed from driver's view prior to test