2008 Mercedes-benz Vito

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Brake drum back plate insecure corroded (1.1.14 (d))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust has a major leak of exhaust gases tail pipe missing (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced all rear suspension mounting prescribed areas (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced inner sills slight corrosion (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner sills corroded (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Service brake lagging in operation (1.2.1 (d))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

rear tyre treads getting low

Offside Front Position lamp not working (4.2.1 (a))

brake pad warning light on

rear tyre treads getting low

front tyre treads wearing low

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Centre Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)