2002 Saab 9-3

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Exhaust mounting defective (6.1.2 (a))

Fuel Pipe/s corroded fuel filler pipe clip corroded ()

Nearside Rear tyre side wall cracked and damaged

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

engine light on

exhaust blowing

Nearside Rear Brake hose excessively deteriorated (3.6.B.4d)

Offside Rear Brake hose excessively deteriorated (3.6.B.4d)

Centre Exhaust system not adequately supported (7.1.1)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front suspension has excessive play in a track control arm inner bush (2.5.B.2b)

Offside Front suspension has excessive play in a track control arm inner bush (2.5.B.2b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Clamp for fuel filter filler cooroded through

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

o s f tyre cracked and cut sidewall

Offside Front coil spring fractured (2.4.C.1a)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Centre Exhaust system not adequately supported (7.1.1)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear rear brake application uneven (3.7.B.2)