2003 Suzuki Jimny

Central Rear Fuel tank insecure (6.1.3 (a) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting marked (6.2.2 (d) (i))

Offside Rear Fuel tank leaking (6.1.3 (b) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting marked (6.2.2 (d) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Power steering pipe/hose has slight seepage (2.1.5 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Coil spring corroded (5.3.1 (b) (i))

Rear Passenger seat(s) missing at time of test ()

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Brake disc significantly and obviously worn corroded (1.1.14 (a) (i))

Rear Brake pipe excessively corroded across axle (1.1.11 (c))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Coil spring corroded (5.3.1 (b) (i))

Rear Passenger seat(s) missing at time of test ()

Front swivels corroded

Suspension arm pin or bush worn but not resulting in excessive movement both rear trailing arms (5.3.4 (a) (i))

trims covering outersill not allowing full inspection

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired cross member/body mount (5.3.6 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords split in sidewall (5.2.3 (d) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor/body mount (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under vallance (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength centre cross member (5.3.6 (a) (i))

Front swivels corroded

Suspension arm pin or bush worn but not resulting in excessive movement both rear trailing arm bush's (5.3.4 (a) (i))

trims covering outer sill not allowing inspection

Rear unable to check rear seat belts due to dog cage

Brake pipe likely to become detached or damaged front to rear (1.1.11 (d) (ii))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced body mounting (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced body mounting (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced body mounting (7.1.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear unable to check rear seat belts due to dog cage

Central Rear Brake pipe corroded, covered in grease or other material all pipes going into brake comp (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Fuel Pipe/s corroded front to rear ()

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Seat belt anchorage prescribed area is corroded but not considered excessive rear floor above the axle corroded right across (7.1.1 (a) (i))

Brake pipe excessively corroded both front to rear (1.1.11 (c))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced floor holed (7.1.1 (a) (i))

Central Rear Brake pipe corroded, covered in grease or other material all pipes going into brake comp (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Fuel Pipe/s corroded front to rear ()

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Seat belt anchorage prescribed area is corroded but not considered excessive rear floor above the axle corroded right across (7.1.1 (a) (i))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting central - body mount (6.2.2 (d) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength central - chassis leg (5.3.6 (a) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear Brake pipe excessively corroded across axle (1.1.11 (c))

Brake hydraulic reservoir fluid level below minimum level (1.1.10 (d) (i))

Brake pipe corroded, covered in grease or other material both - front to rear (1.1.11 (c))

Fuel Pipe/s corroded ()

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear seats folded flat at time of test - unable to fully inspect rear seat belts

Sill covers fitted

Underside Corroded

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front and rear suspension arm mountings (5.3.6 (a) (i))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake pipe slightly corroded both - front to rear (3.6.B.2c)

Fuel pipes corroded

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive chassis leg - at trailing arm mounting point (2.4.A.3)

Rear Brake pipe slightly corroded across axle (3.6.B.2c)

Nearside Front Axle swivel joint has excessive movement between a swivel joint and its housing kingpin bearings (2.5.A.1b)

Nearside Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Nearside Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

engine mounting deteriorated resulting in excessive movement transfer box mounting fractured/insecure (6.1.D.1a)

Brake pipe slightly corroded both - front to rear (3.6.B.2c)

Fuel pipes corroded

Gearbox mounting defective ()

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive chassis leg - at trailing arm mounting point (2.4.A.3)

Rear Brake pipe slightly corroded across axle (3.6.B.2c)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

front brake application uneven (3.7.B.2) DANGEROUS

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Nearside Front brake caliper has restricted free movement (3.5.1k)

Child seat fitted not allowing full inspection of adult belt

Fuel pipe/s corroded

vehicle has been sprayed with waxoyl underneath

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

underside is corroding

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Shock absorber has negligible damping effect (2.7.5) DANGEROUS

Offside Front Steering pivot point has slight play (2.2.B.1g)

Nearside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

fuel pipes corroded

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Axle swivel joint has excessive movement between a swivel joint and its housing (2.5.A.1b)