2006 Alfa Romeo GT

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Coil spring corroded all four (5.3.1 (b) (i))

Front Shock absorbers has slight external damage to the casing both corrosion (5.3.2 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front sill corroded and holed outside 30cm of any prescribed areas

Offside Rear Shock absorbers has slight external damage to the casing corrosion (5.3.2 (b))

Front Brake hose has slight corrosion to ferrule Both side (1.1.12 (f) (i))

Front Coil spring corroded Both side (5.3.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened Both side (5.3.3 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake hose has slight corrosion to ferrule Both side (1.1.12 (f) (i))

Rear Coil spring corroded Both side (5.3.1 (b) (i))

Brake performance not tested Due to o/s/r brake pads metal to metal and brake disc damaged (1.2.1 (g))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Upper Suspension arm pin or bush excessively worn Excessive movement (5.3.4 (a) (i))

Offside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Brake pad(s) less than 1.5 mm thick Metal to metal (1.1.13 (a) (ii)) DANGEROUS

Front Brake hose has slight corrosion to ferrule Both side (1.1.12 (f) (i))

Front Coil spring corroded Both side (5.3.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened Both side (5.3.3 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake hose has slight corrosion to ferrule Both side (1.1.12 (f) (i))

Rear Coil spring corroded Both side (5.3.1 (b) (i))

Front Exhaust has a major leak of exhaust gases front pipe on flexi blowing (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Outer Seat belt anchorage prescribed area is excessively corroded SILL (5.2.6)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Central Exhaust system not adequately supported mounting corroded and insecure (7.1.1)

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Suspension component mounting prescribed area is excessively corroded INNER AND OUTER SILLS CORRODED HEAVILY (2.4.A.3)

Offside Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength INNER AND OUTER SILLS CORRODED HEAVILY (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

rear pads below half worn on the offside outer

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

rear pads below half worn on the offside outer

Horn not working (1.6.2a)

Nearside Brake cable has wires broken and is significantly weakened (3.5.1b)

Offside Brake cable has wires broken and is significantly weakened (3.5.1b)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

off front tyre is cut on the outer side wall but not to the cords

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

off front tyre is cut on the outer side wall but not to the cords

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Nearside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2) DANGEROUS

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f) DANGEROUS

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)