2001 Mazda MX-5

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Service brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Suspension arm pin or bush worn but not resulting in excessive movement All Rear (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower intercooler hose and coolant hoses chafing

Nearside Front Upper suspension arm ball joint welded in, no play detected and functioning as intended

Offside Front Upper suspension arm ball joint welded in, no play detected and functioning as intended

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Front Lower intercooler hose and coolant hoses chafing

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Upper suspension arm ball joint welded in, no play detected and functioning as intended

Offside Front Upper suspension arm ball joint welded in, no play detected and functioning as intended

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Upper Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

clutch slave cylinder insecure

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened n/s & o/s (1.1.14 (a) (ii))

Rear Coil spring corroded n/s & o/s (5.3.1 (b) (i))

Rear Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits due to exhaust blowing (8.2.1.2 (c))

Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened n/s & o/s (1.1.14 (a) (ii))

Rear Coil spring corroded n/s & o/s (5.3.1 (b) (i))

Rear Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Tyre slightly damaged/cracking or perishing n/s & o/s (5.2.3 (d) (ii))

Nearside Outer Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened n/s & o/s (1.1.14 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Rear Exhaust mounting defective (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Both rear inner wheel arches corroding

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced subframe (6.1.1 (c) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases to centre joint (6.1.2 (a))

Suspension component mounting prescribed area is corroded but not considered excessive both front inner wings (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both inner sills (5.3.6 (a) (i))

Anti-lock braking system warning lamp does not illuminate (1.6 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both front inner wings (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both inner sills (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis rail (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis rail (2.4.A.3)

both rear inner wheel arches corroded, but not in a prescribed area

various parts of vehicle has slight corrosion

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

nearside front brake slightly binding when turned by hand.

offside front brake slightly binding when turned by hand.

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

nearside front brake slightly binding when turned by hand.

offside front brake slightly binding when turned by hand.

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Outer Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front brake disc slightly pitted (3.5.1h)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)