2008 Toyota Aygo

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill corroded on previous weld (6.1.1 (c) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill corroded on previous weld (6.1.1 (c) (i))

Rear Tyre slightly damaged/cracking or perishing BOTH (5.2.3 (d) (ii))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both sides (5.1.2 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both sides (5.1.2 (b) (i))

Central Rear Brake pipe corroded, covered in grease or other material mains to axal been undesealed (1.1.11 (c))

Front Brake disc worn, but not excessively both sides (1.1.14 (a) (i))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. both sides (1.4.2 (a) (i))

Front Headlamp not working on dipped beam both sides (4.1.1 (a) (ii))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outter sill hole marked in yellow (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outter sill hole marked in yellow (6.2.2 (d) (i))

Central Rear Brake pipe corroded, covered in grease or other material mains to axal been undesealed (1.1.11 (c))

Front Brake disc worn, but not excessively both sides (1.1.14 (a) (i))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. both sides (1.4.2 (a) (i))

Backbox Corroded

Underbody Has Surface Corrosion all over

Rear Brake pipe corroded, covered in grease or other material both front to rear pipes corroded at rear end (1.1.11 (c))

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside rear brake binding (3.7.B.1) DANGEROUS