2003 Toyota Land Cruiser

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Emissions unable to be completed due to exhaust broken in center of vehicle (8.2.2.2 (e))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt insecure (6.1.7 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength radiator support near anti roll bar mounting (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock absorber top mount (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension arm attachment bracket/mounting insecure and impairing directional stability arm to axle (5.3.3 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Front Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive spring mounts (5.3.6 (a) (i))

Rear axle corroded/ suspension mounts

Vehicle structure is corroded but structural rigidity is not significantly reduced chassis heavily corroded front and rear (6.1.1 (c) (i))

corrosion on suspension components

towbar and chassis areas undersealed

vehicle undertrays corroded

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced n/s and o/s (6.1.1 (c) (i))

Hydraulic brake cylinder operating mechanism has excessive travel (1.1.16 (e) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced body mount (6.1.1 (c) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced trailing arm and link area (6.1.1 (c) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Towbar excessively corroded within 30cm of towbar mounting n/s and o/s chassis (6.1.6 (i) (i))

Windscreen washer not working (3.5 (a))

Front Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive spring mounts (5.3.6 (a) (i))

Rear axle corroded/ suspension mounts

Vehicle structure is corroded but structural rigidity is not significantly reduced chassis heavily corroded front and rear (6.1.1 (c) (i))

corrosion on suspension components

vehicle undertrays corroded

Exhaust has a minor leak of exhaust gases centre box (6.1.2 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced throughout underside of vehicle (6.1.1 (c) (i))