2004 Subaru Impreza

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge worn on edge (5.2.3 (e))

Suspension arm pin or bush worn but not resulting in excessive movement all rear lower outer arm bushes (5.3.4 (a) (i))

underside has been wax oiled

Brake performance unable to be tested due to leaking brake pipe (1.2.1 (g))

Nearside Rear Vehicle structure inadequately repaired such that structural rigidity is significantly reduced near shocker mount (6.1.1 (d) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Rear Brake pipe connection leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge worn on edge (5.2.3 (e))

Suspension arm pin or bush worn but not resulting in excessive movement all rear lower outer arm bushes (5.3.4 (a) (i))

underside has been wax oiled

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Rear Integral body structure inadequately repaired such that structural rigidity is significantly reduced inner wheel arch plates glued on (6.1.1 (d) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Driver's airbag missing (7.1.5 (a))

Emissions unable to be completed due to missing catalytic (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Horn not working (7.7 (a))

Nearside Front Sub-frame corroded and seriously weakened this cannot be welded (5.3.3 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Integral body structure inadequately repaired such that structural rigidity is significantly reduced inner wheel arch plates glued on (6.1.1 (d) (i))

Offside Front Sub-frame corroded and seriously weakened this cannot be welded (5.3.3 (b) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

sill coverers fitted at time of test

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake disc worn, pitted or scored, but not seriously weakened all (1.1.14 (a) (ii))

Brake hose has slight corrosion to ferrule both rear (1.1.12 (f) (i))

Headlamp lens slightly defective both front (4.1.1 (b) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Tyre slightly damaged/cracking or perishing both rear (5.2.3 (d) (ii))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

rear arches corroded

subframes corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Windscreen washer not working (3.5 (a))

Brake hose has slight corrosion to ferrule Both rear. (1.1.12 (f) (i))

Headlamp lens slightly defective Both front. (4.1.1 (b) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Tyre slightly damaged/cracking or perishing Both rear. (5.2.3 (d) (ii))

Tyre worn close to legal limit/worn on edge Both rear. (5.2.3 (e))

Rear Brake hose has slight corrosion to ferrule Both side (1.1.12 (f) (i))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both sides inner wings (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength both sides (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded to hose (1.1.11 (c))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both sides inner wings (6.1.1 (c) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive anti roll mounting area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive anti roll mounting area (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive @ anti roll bar mounting area (5.3.6 (a) (i))

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Fuel hose leaking (6.1.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Lower Brake pad(s) locking device insecure brake pad retaining pin (3.5.1l)

Offside Rear Suspension component mounting prescribed area is excessively corroded @ trailing arm mounting area (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Nail in tyre

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nail in nearside front tyre

engine management light on

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

on brake test (possible sticking brake pad)

Both front tyres wearing low on inner & outer edges

Brake pad(s) wearing thin (3.5.1g)