2006 Mazda RX-8

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Headlamp aim too low both (4.1.2 (a))

Nearside Rear Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Power steering malfunctioning (2.1.5 (a))

Seat belt anchorage prescribed area strength or continuity significantly reduced both sills (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Service brake binding but not excessively both rear (1.2.1 (f))

Sub-frame corroded but not seriously weakened front and rear (5.3.3 (b) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp aim too high and too far to the left. (1.8)

Centre Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Front Brake pad(s) wearing thin (3.5.1g)

Front and rear brake discs slightly pitted

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Front and rear brake discs slightly pitted

Rear Brake pad(s) wearing thin (3.5.1g)