2006 Subaru Impreza

Front Drive shaft joint constant velocity boot severely deteriorated both (6.1.7 (g) (i))

Rear Inner Suspension component mounting repair covered in underseal both sides sills (5.3.6 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Drive shaft joint constant velocity boot severely deteriorated both (6.1.7 (g) (i))

Offside Rear Inner Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated leaking (6.1.7 (g) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated leaking (6.1.7 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

outer sill covers fitted at time of test preventing full inspection

Power steering pipe/hose has slight seepage (2.1.5 (a))

Nearside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Power steering fluid level below minimum (2.1.5 (b) (i))

Power steering pipe/hose has slight seepage (2.1.5 (a))

Anti-roll bar pin or bush worn but not resulting in excessive movement both front d bushes (5.3.4 (a) (i))

Headlamp lens slightly defective both front (4.1.1 (b) (i))

Offside Rear Suspension component mounting repair covered in underseal inner sill area (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

nearside front ball joint bolt fixing modified

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner sills (5.3.6 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

both rear brake discs corroded

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

both rear brake discs corroded