2007 Mercedes-benz Vito

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

underbody has general corrosion!

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced under (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced under (6.1.1 (c) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Tyre worn close to legal limit/worn on edge both inner edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

litel resever travel

Rear Brake pipe slightly corroded both rear (3.6.B.2c)

both rear tyres on limit

Exhaust system not adequately supported middle clamp missing and blowing slightly (7.1.1)

Offside Rear coil spring broken (2.4.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Upper Stop lamp not working (1.2.1b)

Headlamp aim too high both (1.8)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' objects in drivers veiw (8.3.1e)

both rear tyres on limit

Exhaust clamp missing but adequately secured

Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

Play in steering rack inner joint(s)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)