2008 Volvo V50

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened (5.3.1 (b) (i))

Offside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Suspension arm corroded but not seriously weakened advise replacement (5.3.3 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Coil spring corroded rear coil springs (5.3.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bonded bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bonded bush (5.3.4 (a) (i))

Offside Front Obligatory mirror seriously damaged, affecting the rear view (3.3 (b) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Coil spring corroded rear coil springs (5.3.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bonded bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner bonded bush (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. reserve travel (1.4.2 (a) (i))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

rear suspension components corroded

advise exhaust system corroded

Fuel pipe leaking diesel fuel pipes & component leaking (6.1.3 (b) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

advise exhaust system corroded

Brake disc significantly and obviously worn both rear (1.1.14 (a) (i))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Rear Service brake excessively fluctuating (1.2.1 (e))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Rear Service brake excessively fluctuating (1.2.1 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Both front brake disc backing plates loose

Nearside Rear Exhaust heat shield loose

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Front brake disc pitted and scored

Nearside Front cv boot has slight damage (pin hole)

Rear brake disc pitted and scored

Rear brakes slight fluctuation

centre exhaust outer shell broken

silencer heat shield loose

slight fluctuating at brake readings

slight leak at n/s cv boot

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

slight fluctuating at brake readings

slight leak at n/s cv boot

front brake discs corroded

front brake fluctuating, but not excessively (3.7.B.3)

front brake imbalance

front suspension arms rear bushes worn

rear brake pads worn

rear tyres wearing at inner edge

silencer corroded

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

n/s no plate light dull

o/s/f tyre cut at inner sidewall

o/s/f tyre worn at edges

Nearside Front coil spring broken (2.4.C.1a)

Offside Front coil spring broken (2.4.C.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

o/s/f tyre worn at edges

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

n/s no plate light dull

o/s/f tyre cut at inner sidewall

Nearside Outer Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)