2008 Toyota Aygo

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced both side sills (6.1.1 (c) (i))

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner sill (5.3.6 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases slightly insecure (6.1.2 (a))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively damaged significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

headlamp lens condition

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

front brake discs are corroded on inner faces