2012 BMW 1 Series

HEADLIGHT ACCESS COVERS MISSING BOTH FRONT HEADLIGHTS,

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Play in steering rack inner joint(s)

Oil leak, but not excessive (8.4.1 (a) (i))

WARNING ON DASH INDICATED FAULT WITH ADAPTIVE HEADLIGHT SYSTEM

Nearside Front Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit (4.11 (c) (ii))

Nearside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

HEADLIGHT ACCESS COVERS MISSING BOTH FRONT HEADLIGHTS,

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Play in steering rack inner joint(s)

Oil leak, but not excessive (8.4.1 (a) (i))

WARNING ON DASH INDICATED FAULT WITH ADAPTIVE HEADLIGHT SYSTEM

Front Tyres worn on edge

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre worn on edge

offside rear tyre worn inner edge

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both front discs pitted/corroded inner and outer faces (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened both rear discs lightly pitted (1.1.14 (a) (ii))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both front discs pitted/corroded inner and outer faces (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened both rear discs lightly pitted (1.1.14 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

chip in windscreen.

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)