2003 Mazda 6

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill to underfloor (7.1.1 (a) (i))

Offside Rear Outer Subframe mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Body panel corroded and likely to cause injury Both outer wheel arches (6.2.1 (a) (i))

Rear Lower Suspension arm corroded and seriously weakened Both (5.3.3 (b) (i))

Front Tyre worn close to the legal limit both (4.1.E.1)

vehicle corroding

Front Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Front Tyre worn close to the legal limit both (4.1.E.1)

vehicle corroding

General under vehicle corrosion but not excessive.

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded Wheel arch (2.4.A.3)

Nearside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Inner Front Brake pad(s) wearing thin (3.5.1g)

both front tyres wearing low

o/s/r brake binding slightly

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

both rear tyres wearing low

exhaust system corroding

n/s/f inner brake pad wearing low

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

both front tyres wearing low

Nail in nearside rear tyre