2006 Toyota Aygo

Central Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii))

Emissions not tested Exhaust leak (8.2.1.2 (d))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Tyre(s) with different structures are fitted across the same axle (5.2.3 (c))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Integral body structure inadequately repaired such that structural rigidity is significantly reduced Sill (6.1.1 (d) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Brake cable knotted (1.1.15 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Headlamp aim projected beam image is obviously incorrect BOTH (4.1.2 (c))

Front Headlamps matched pair incorrect colour BOTH (4.1.4 (a))

Front Suspension arm pin or bush excessively worn BOTH SIDES REAR BUSHES (5.3.4 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL AT REAR (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Undertray likely to become detached INNER WING ALSO CATCHING WHEEL (6.2.1 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Tyre worn close to the legal limit worn to limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Emissions not tested rough running MIL lamp on (7.3.A.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Tyre worn close to the legal limit worn to limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

engine management light showing

long handbrake travel

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

engine management light showing

long handbrake travel

Child seat fitted not allowing full inspection of adult belt

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

n/s/f tyre has a screw in tread

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)