2006 Toyota Aygo

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Integral body structure is corroded but structural rigidity is not significantly reduced wing both sides (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced under sill front 2 back both sides (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Suspension component mounting repair covered in underseal both sides (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Integral body structure is corroded but structural rigidity is not significantly reduced wing both sides (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced under sill front 2 back both sides (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Suspension component mounting repair covered in underseal both sides (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e))

Body panel slightly loose Corroded (6.2.1 (a) (i))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i)) Front Anti-roll bar linkage pin or bush worn but not resulting in

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c)) Nearside Rear Brake pipe corroded, co

movement Both Sides (5.3.4 (a) (i)) Offside Rear Service brake binding but not excessively (1.2.1 (f)

Emissions not tested (8.2.1.2 (d))

Body panel slightly loose Corroded (6.2.1 (a) (i))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i)) Front Anti-roll bar linkage pin or bush worn but not resulting in

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c)) Nearside Rear Brake pipe corroded, co

movement Both Sides (5.3.4 (a) (i)) Offside Rear Service brake binding but not excessively (1.2.1 (f)

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both Sides (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened Both Sides (1.1.14 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both Sides (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened Both Sides (1.1.14 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Brake pipe slightly corroded to drum (3.6.B.2c)

park brake just met minimum requirement of 16%

Nearside Headlamp aim too low cannot adjust! (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Brake pipe slightly corroded to drum (3.6.B.2c)

park brake just met minimum requirement of 16%

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

engine management lamp on

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim too high (1.8)

Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

all wheel rim inner edges are slightly dented