MOT Status
ValidMileage
144,772 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Seat belt anchorage prescribed area is corroded but not considered excessive inner sill area (7.1.1 (a) (i))
Nearside Front Road wheel badly distorted inner metal rim (5.2.2 (c) (i))
Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill closing panel / inner wing (5.3.6 (a) (i))
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer sill area (7.1.1 (a) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))
Nearside Outer Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))
Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Seat belt anchorage prescribed area is corroded but not considered excessive inner sill area (7.1.1 (a) (i))
Rear Subframe corroded
Emissions unable to be completed (8.2.1.2 (d))
Front Exhaust has a major leak of exhaust gases (6.1.2 (a))
Front Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))
Front Exhaust system insecure (6.1.2 (a))
Rear Subframe corroded
Front Oil leak, but not excessive (8.4.1 (a) (i))
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Nearside Rear Service brake excessively binding (1.2.1 (f))
Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Indicator switch faulty (4.4.2 (a) (i))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Wheel bearing has slight play (5.1.3 (a) (i))
Offside Rear Service brake binding but not excessively (1.2.1 (f))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))
Front Tyre tread depth below requirements of 1.6mm both sides (5.2.3 (e)) DANGEROUS
Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides. (5.3.4 (a) (i))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Service brake fluctuating, but not excessively both (1.2.1 (e))
Rear Windscreen wiper blade defective (3.4 (b) (i))
Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))
Front Windscreen wiper does not clear the windscreen effectively and insecure. (3.4 (b) (ii))
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))
Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides. (5.3.4 (a) (i))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Service brake fluctuating, but not excessively both (1.2.1 (e))
Rear Windscreen wiper blade defective (3.4 (b) (i))
Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Oil leak, but not excessive (8.4.1 (a) (i))
Brake slack adjuster incorrectly adjusted hand brake too high. (1.1.18 (a))
Nearside Front Headlamp not working on dipped beam some time works and some time not. (4.1.1 (a) (ii))
Nearside Rear Parking brake efficiency below requirements (1.4.2 (a) (i))
Offside Front Headlamp aim too low (4.1.2 (a))
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))
Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS
Offside Rear Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS
Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))
Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Offside Front Service brake binding but not excessively (1.2.1 (f))
Oil leak, but not excessive (8.4.1 (a) (i))
Front Oil leak, but not excessive (8.4.1 (a) (i))
Nearside Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Anti-roll bar modified but not seriously weakened (5.3.3 (c) (i))
Offside Front Coil spring corroded (5.3.1 (b) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Emissions not tested (8.2.2.2 (e))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Front Oil leak, but not excessive (8.4.1 (a) (i))
Nearside Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Anti-roll bar modified but not seriously weakened (5.3.3 (c) (i))
Offside Front Coil spring corroded (5.3.1 (b) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))
Nearside Parking brake inoperative on one side (1.4.1 (a))
Offside Brake pipe excessively corroded front to rear (1.1.11 (c))
Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Brake pipe slightly corroded (3.6.B.2c)
Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rearmost (2.4.G.2)
Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both rearmost (2.4.G.2)
Front registration plate deteriorated but not likely to be misread (6.3.1d)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Oil leak ()
exhaust brackets corroded
Front Tyre has ply or cords exposed both (4.1.D.1b)
Front position lamp(s) not working both side lights (1.1.A.3b)
Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Registration plate lamp not working (1.1.C.1d)
Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both rearmost (2.4.G.2)
Front registration plate deteriorated but not likely to be misread (6.3.1d)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Oil leak ()
exhaust brackets corroded
Front Tyre worn close to the legal limit (4.1.E.1)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
noise from engine
slight play in both front wishbone bushes
Nearside Front Brake pad(s) wearing thin (3.5.1g)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Brake pad(s) wearing thin (3.5.1g)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Rear Exhaust has a minor leak of exhaust gases (7.1.2)
How Reliable is the Peugeot 107?
Based on 2,229,410 MOT tests across 139,779 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
YF08 PUK is a 2008 Peugeot 107 in Black with a 998cc petrol engine. This vehicle has been through 25 MOT tests with a personal pass rate of 64%.
Across all 2008 Peugeot 107 models, the average MOT pass rate is 74.1% with a typical mileage of 54,654 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Peugeot 107 fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 42,280 recorded failures. If you're considering buying YF08 PUK, it's worth having these areas checked by a mechanic before committing.
The Peugeot 107 typically stays on UK roads for around 21 years. At 18 years old, this Peugeot 107 is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of YF08 PUK?
You can check the full history of YF08 PUK by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was YF08 PUK registered?
YF08 PUK is a 2008 Peugeot 107, first registered on 23 July 2008.
Is YF08 PUK safe to buy?
The MOT history for YF08 PUK shows 25 tests with a 64% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does YF08 PUK have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on YF08 PUK. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.