2004 Subaru Legacy

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Integral body structure is repaired but structural rigidity is not significantly reduced crossmember (6.1.1 (d) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

General underbody surface corrosion

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front suspension has surface corrosion

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear suspension undersealed

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Brake pipe connection leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Brake pipe leaking on a hydraulic braking system above fuel tank (1.1.11 (b) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

exhaust heat shield loose

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

noise from diff or wheel bearings at rear

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

noise from diff or wheel bearings at rear

All four brake discs have a moderate wear ridge.

Brake pedal pad worn, change soon.

Front Bonded suspension unit deteriorated but can function as intended Both sides, lower arm rear bush, change soon. (2.4.F.3)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

All four brake discs have a moderate wear ridge.

Brake pedal pad worn, change soon.

Front Bonded suspension unit deteriorated but can function as intended Both sides, lower arm rear bush, change soon. (2.4.F.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, keep a check. (2.4.F.3)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint Change soon (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit 2.5mm keep a check. (4.1.E.1)

Offside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, keep a check. (2.4.F.3)

Offside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a ball joint Change soon (2.4.G.2)

Offside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, keep a check. (2.4.F.3)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint Change soon (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit 2.5mm keep a check. (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, keep a check. (2.4.F.3)

Offside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a ball joint Change soon (2.4.G.2)

Offside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, change soon. (2.4.F.3)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, change soon. (2.4.F.3)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, change soon. (2.4.F.3)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Bonded suspension unit deteriorated but can function as intended Lower arm rear bush, change soon. (2.4.F.3)

Offside Headlamp aim too low (1.8)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear registration plate insecure (6.3.1b)

Under-trays fitted obscuring some underside components

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear fog lamp has light sources not illuminating, but not more than 50% (1.3.2b)

exhaust system partially deteriorated

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear fog lamp has light sources not illuminating, but not more than 50% (1.3.2b)

exhaust system partially deteriorated

Exhaust has part of the system slightly deteriorated (7.1.1a)

Inside edge of front discs becoming pitted

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

unable to rotate front wheels due to the four wheel drive system to fully check front wheel bearings.

Front Brake pad(s) wearing thin (3.5.1g)