2005 Suzuki Jimny

all the underbody corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

All steering, suspension and braking components corroded

Chassis corroded but not seriously weakened

Coolant leak

Front Prop shaft joint worn, but not excessively (6.1.7 (c) (i))

Front Prop shaft joint worn, but not excessively (6.1.7 (c) (i))

Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Lower heavily undersealed

Shock absorbers has light misting of oil both front (5.3.2 (b))

exhaust system deteriated

Battery insecure and likely to fall from carrier inner wheel arch very corroded (4.13 (a) (ii))

Horn sound not in accordance with requirements (7.7 (c))

Shock absorbers has light misting of oil both front (5.3.2 (b))

exhaust system deteriated

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Fuel Pipe/s corroded

rear section of exhaust deteriated

slight leak frm nearside front swivel joint seal

slight leak of oil n/sswivel ball seal

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases gasket (6.1.2 (a))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

slight leak of oil n/sswivel ball seal

Nearside Front steering hub has slight oil leak from sphere seal

oil leak on nearside front swivel housing

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Side repeater not working (1.4.A.2c)

oil leak on nearside front swivel housing

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust system not adequately supported (7.1.1)

Nearside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

rear brake application uneven (3.7.B.2)

Nearside Inner Rear Brake pipe slightly corroded (3.6.B.2c)

Brake pipe excessively corroded (3.6.B.2c)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp aim too high (1.8)

Nearside Inner Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Stub axle has slight vertical movement between stub axle and axle beam (2.5.A.1a)

Offside Headlamp aim too low (1.8)

Nearside Front Axle swivel joint has slight play (2.5.A.3b)

Offside Front Axle swivel joint has excessive movement between a swivel joint and its housing (2.5.A.1b)