2005 Suzuki Jimny

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Steering component mounting prescribed area is corroded but not considered excessive chassis area (2.1.2 (e) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin all (1.1.13 (a) (ii))

Suspension component mounting repair covered in underseal various places all over underside of vehicle (5.3.6 (a) (i))

Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security CORROSION BEHIND BOTH HEADLIGHT POSITIONS AND FRONT SECTIONS OF THE INNER WINGS (6.2.2 (d) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Fuel Pipe/s corroded ()

Nearside Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting CORROSION AROUND THE FORWARD BODY MOUNT (6.2.2 (d) (i))

Offside Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting CORROSION AROUND THE FORWARD BODY MOUNT (6.2.2 (d) (i))

Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security CORROSION BEHIND BOTH HEADLIGHT POSITIONS AND FRONT SECTIONS OF THE INNER WINGS (6.2.2 (d) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Fuel Pipe/s corroded ()

Both headlight bucket holes have corrosion

Front Axle swivel pins and bushes swivel pin and/or bush slightly worn Both front king pins have play (5.1.2 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Headlamp lens slightly defective Lens slight deteriorated/misted (4.1.1 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt Boot cracking (2.1.3 (g) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Exhaust silencer rubber not connected, exhaust still secure

Offside Rear Inner arch area is HEAVILY corroded

Offside Rear Tail light lens cracked

Front Windscreen wiper does not clear the windscreen effectively Both front wiper rubbers torn/split (3.4 (b) (ii))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner arch area (6.2.2 (d) (i))

Front Axle swivel pins and bushes swivel pin and/or bush slightly worn Both front king pins have play (5.1.2 (b) (i))

Front Both front headlight bucket holes have corrosion

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Headlamp lens slightly defective Headlamp lens slight deteriorated/misted (4.1.1 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Exhaust silencer rubber not connected - exhaust still secure

Offside Rear Inner arch area has corrosion

Offside Rear Taillight lens cracked

Front Axle swivel pins and bushes swivel pin and/or bush slightly worn Both front king pins have play (5.1.2 (b) (i))

Front Both front headlight bucket holes have corrosion

Front Inner Both front inner arches have heavy corrosion

Offside Rear Rear silencer exhaust rubber not connected - exhaust still secure

Offside Rear Taillight lens cracked

Rear Both rear inner wing areas have corrosion

Nearside Front Drag link end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt Boot split (2.1.3 (g) (ii))

Offside Front Drag link end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt Boot split (2.1.3 (g) (ii))

Front Axle swivel pins and bushes swivel pin and/or bush slightly worn Both front king pins have play (5.1.2 (b) (i))

Front Both front headlight bucket holes have corrosion

Front Inner Both front inner arches have heavy corrosion

Offside Rear Rear silencer exhaust rubber not connected - exhaust still secure

Offside Rear Taillight lens cracked

Rear Both rear inner wing areas have corrosion

Brake pipe corroded, covered in grease or other material ALL BRAKE PIPES ARE COVERED IN UNDER SEAL !! (1.1.11 (c))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Nearside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Steering box has excessive free play detected at the steering wheel (steering box fitted) (2.3 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Brake pipe corroded, covered in grease or other material ALL BRAKE PIPES ARE COVERED IN UNDER SEAL !! (1.1.11 (c))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Nearside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner wing area (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material x 2 (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill x wheel arch (5.3.6 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill x wheel arch (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear inner sills corroded

Rear of car rusty

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear rear end of vehicle /suspension rusty.

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill excessively corroded (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch corroded . (6.2.2 (d) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill excessively corroded (6.2.2 (d) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Rear rear end of vehicle /suspension rusty.

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material slight corrosion . front to rear brake pipe . (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Suspension component likely to fail stabilizer link excessively worn on rear of vehicle . (5.3.3 (b) (ii)) DANGEROUS

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material slight corrosion . front to rear brake pipe . (1.1.11 (c))

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner cill (6.1.B.2)

Offside Rear Torsion bar deteriorated by corrosion so that its cross sectional area is reduced and seriously weakened bracket (2.4.E.1b)

Offside Rear Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings inner cill (6.1.B.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Torsion bar deteriorated by corrosion so that its cross sectional area is reduced and seriously weakened (2.4.E.1b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Front suspension has excessive movement at wishbone bearing (2.5.A.1c)

Offside Front Front suspension has excessive movement at wishbone bearing (2.5.A.1c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)