2004 Mazda MX-5

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings N/S and O/S front chassis legs close to suspension mounting (6.1.B.2)

Brake pipe excessively corroded front to rear (3.6.B.2c)

Nearside Front position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Rear Brake pipe excessively corroded across axle (3.6.B.2c)

Registration plate lamp does not illuminate simultaneously with the position lamps Flashing (1.1.C.1a)

All suspension arms corroded

Brake hydraulic reservoir fluid close to minimum level low (3.6.G.1b)

Front brake back plates corroded

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Offside Rear Upper Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front tyres wearing on outer edge

both front tyres scrubbing inner edges

corrosion on front discs inner faces

offside front tyre inner sidewall splitting but no ply visible

rear pads worn

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)