2005 Suzuki Carry

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Fuel Pipe/s corroded ()

Gearbox mounting defective ()

Hazard warning switch faulty (4.4.2 (a) (i))

Nearside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Play in steering rack inner joint(s) ()

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Brake cable damaged but not to excess (1.1.15 (a))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear fog lamp insecure (4.5.1 (c) (i))

Offside Steering rack has slight free play detected at steering wheel rack end (2.3 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Horn not working (7.7 (a))

Nearside Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Steering rack has slight free play detected at steering wheel rack end (2.3 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front chassis corroding

Rear both shockers corroding

steering column has slight side play

Brake lever has insufficient reserve travel (1.1.2 (a))

Exhaust system insecure x3 mounts (6.1.2 (a))

Front Anti-roll bar pin or bush excessively worn d bushes (5.3.4 (a) (i))

Horn not working (7.7 (a) (ii))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded on axle (1.1.11 (c))

Rear fog lamp missing (4.5.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front chassis corroding

Rear both shockers corroding

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

steering column has slight side play

Exhaust system insecure (6.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside Leaf spring fractured (5.3.1 (b) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced footwell (6.1.1 (c) (i))

Exhaust system not adequately supported (7.1.1)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Leaf spring fractured (2.4.B.1a)

Registration plate lamp does not illuminate simultaneously with the position lamps (1.1.C.1a)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Horn not working (1.6.2a)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

engine managment light on

exhaust coroding

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Horn not working (1.6.2a)

Nearside Ball joint has excessive play (2.2.B.1f)

Offside Rear fog lamp not working (1.3.2b)

Steering column locking device insecure (2.1.6)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

engine managment light on

exhaust coroding

front brakes pedal bounce

engine lamp on

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe excessively corroded (3.6.B.2c)

Registration plate lamp not working (1.1.C.1d)

engine lamp on

Exhaust has part of the system slightly deteriorated (7.1.1a)

engine managment light on

Front Brake pad(s) wearing thin (3.5.1g)

Registration plate lamp not working (1.1.C.1d)

Nearside Ball joint has excessive play (2.2.B.1f) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too high (1.8)

Registration plate lamp not working (1.1.5c)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Registration plate lamp not working (1.1.5c)