2006 Toyota Aygo

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Front Suspension component mounting prescribed area is corroded but not considered excessive subframe and suspension components (5.3.6 (a) (i))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Inner Seat belt anchorage prescribed area is corroded but not considered excessive sills (7.1.1 (a) (i))

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle and suspension components (5.3.6 (a) (i))

slight corrosion underbody

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Inner Seat belt anchorage prescribed area is corroded but not considered excessive sills (7.1.1 (a) (i))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear fog lamp switch inoperative (4.5.3 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Inner Seat belt anchorage prescribed area is corroded but not considered excessive sills (7.1.1 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassies legs (5.3.6 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive floors (7.1.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Rear Exhaust has a major leak of exhaust gases joint (6.1.2 (a))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassies legs (5.3.6 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive floors (7.1.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

surface corrosion to all underside

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Brake pipe corroded, covered in grease or other material rear of front to rear (1.1.11 (c))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Brake pipe corroded, covered in grease or other material rear of front to rear (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Rear Emissions not tested (7.0)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brake pad(s) less than 1.5 mm thick (3.5.1g)

brake disc excessively pitted (3.5.1h)