2008 Toyota Aygo

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Rear axle bushes worn

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords both (5.2.3 (d) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear axle bushes worn

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Tyre slightly damaged/cracking or perishing all 4 (5.2.3 (d) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Indicator switch inoperative (4.4.2 (a) (ii))

Offside Front Brake hose excessively damaged (1.1.12 (b) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Tyre slightly damaged/cracking or perishing all 4 (5.2.3 (d) (ii))

Brake pipe excessively corroded both rear section of front to rear (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake lever has little reserve travel (3.1.6b)

rear brake fluctuating, but not excessively (3.7.B.3)

Offside Rear rear parking (secondary) brake grabbing slightly (3.7.B.6b)

Engine covers fitted obscuring some components in the engine bay

Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Under-trays fitted obscuring some underside components

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside rear brake binding (3.7.B.1)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Hydraulic brake cylinder leaking hydraulic fluid (3.6.A.1)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front coil spring broken (2.4.C.1a) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)