2008 Toyota Aygo

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Tyre tread depth below requirements of 1.6mm both front (5.2.3 (e)) DANGEROUS

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases Back box (6.1.2 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure sidewall (5.2.3 (d) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Position lamp slightly affected by the operation of another lamp side and stop reversed (bulb in wrong) (4.2.3 (c))

Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength next to axle mounting (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill near rear subframe mounting. (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing cracked close to cords (5.2.3 (d) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing cracked close to cords (5.2.3 (d) (ii))

Offside Rear brake sticking slightly

Offside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Rear brake sticking slightly

Front Brake pad(s) wearing thin (3.5.1g)