2011 Land Rover Range Rover

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Nail in tyre ()

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security underbody and coomponents (6.2.2 (d) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Integral body structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe excessively corroded Metal brake pipe corroded above rear axle (1.1.11 (c))

Advise corrosion to both front to rear metal brake pipes

Nearside Rear Advise corrosion to metal brake pipe

Offside Front Advise corrosion to metal brake pipe

Offside Rear Advise corrosion to metal brake pipe

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Engine covers fitted obscuring some components in the engine bay

Under shield fitted obscuring some underside components

Oil leaking excessively from engine (8.4.1 (a) (i))

Engine covers fitted obscuring some components in the engine bay

Under shield fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Oil leak ()

Under shield fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Oil leak ()

Under shield fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Oil leak ()

Under shield fitted obscuring some underside components

Nearside Rear scuff on outside sidewall

Offside Rear worn on inner edge

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear scuff on outside sidewall

Offside Rear worn on inner edge

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)