2006 Chevrolet Matiz

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. o/s lower (1.2.1 (b) (i))

Nearside Front top strut mount slight movement

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive part of sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive part of sill (5.3.6 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. n/s lower (1.2.1 (b) (i))

nearside outer sill corroding

sump corroding

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle offside higher (1.2.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

nail in offside rear tyre

nearside outer sill corroding

offside rear tyre cracking

sump corroding

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm distorted (4.1.E.1)

Front Tyre worn close to the legal limit both tyres 2mm/bald inner edges of tread (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is excessively corroded both outer sills (2.4.A.3)

Nearside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust system not adequately supported (7.1.1)

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

Brake pipe slightly corroded (3.6.B.2c)

low effort to offside rear service brake

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

front exhaust bracket broken

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)