2007 Peugeot 107

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Exhaust fumes entering cabin (6.1.2 (b) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement BOTH (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge BOTH (5.2.3 (e))

BOTH FRONT TYRES WORN ON INSIDE EDGE+ON 3mm

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

BOTH FRONT TYRES WORN ON INSIDE EDGE+ON 3mm

EXHAUST BLOWING ON JOINT

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Windscreen wiper blade defective (3.4 (b) (i))

Front front tie rod rubber bushes worn / also tyres wearing inner edges

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear exhaust pipe at rear corroded slightly blowing

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (i))

Nearside Rear registration lamp lens missing

Centre Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both front (2.4.G.2)

Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both front (2.4.G.2)

Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)