2008 Proton GEN-2

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Headlamp aim too high (4.1.2 (a))

Nearside Front Anti-roll bar linkage likely to fail (5.3.3 (b) (ii))

Offside Front Anti-roll bar linkage likely to fail (5.3.3 (b) (ii))

Battery insecure (1.9.1)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Fuel pipe excessively damaged filler neck pipe (7.2.2)

Nearside Front Wheel nut(s) loose (4.2.A.1e)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

BRAKE PIPE TO OSR FLEXY CORRODING.

ENGINE MANAGEMENT WARNING LAMP STAYING ON.

NSR TYRE SLIGHT SCRUBBING OFF INNER EDGE.

OSR TYRE SCRUBBING OFF INNER EDGE.

OSF TYRE SCRUBBING OFF INNER EDGE AND ON 2MM IN PARTS

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)