MOT Status
ExpiredMileage
104,609 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Emissions unable to be completed (8.2.1.2 (d))
Exhaust emits dense blue smoke at idle (8.2.1.2 (f))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
All exhaust corroded but supported.
Brake disc worn, pitted or scored, but not seriously weakened Nearside and offside front (1.1.14 (a) (ii))
Front Exhaust mounting defective (6.1.2 (a))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Front and rear all suspension components corroded but not seriously weakened.
Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Front Service brake binding but not excessively (1.2.1 (f))
Nearside Headlamp lens slightly defective (4.1.1 (b) (i))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))
Parking brake lever pivot obviously worn Release baton defective (1.1.6 (b) (i))
Suspension component mounting prescribed area is corroded but not considered excessive Nearside and offside rear axle mountings (5.3.6 (a) (i))
Suspension component mounting repair covered in underseal Nearside rear outer sill (5.3.6 (a) (i))
Suspension component mounting repair covered in underseal Offside rear inner sill (5.3.6 (a) (i))
Nearside Front Stop lamp(s) adversely affected by the operation of another lamp Position lamp (4.3.3 (b))
Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 155/65r14 (5.2.3 (d) (i))
Offside Front Position lamp not working (4.2.1 (a) (ii))
Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))
All exhaust corroded but supported.
Brake disc worn, pitted or scored, but not seriously weakened Nearside and offside front (1.1.14 (a) (ii))
Front Exhaust mounting defective (6.1.2 (a))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Front and rear all suspension components corroded but not seriously weakened.
Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Nearside Front Service brake binding but not excessively (1.2.1 (f))
Nearside Headlamp lens slightly defective (4.1.1 (b) (i))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))
Parking brake lever pivot obviously worn Release baton defective (1.1.6 (b) (i))
Suspension component mounting prescribed area is corroded but not considered excessive Nearside and offside rear axle mountings (5.3.6 (a) (i))
Suspension component mounting repair covered in underseal Nearside rear outer sill (5.3.6 (a) (i))
Suspension component mounting repair covered in underseal Offside rear inner sill (5.3.6 (a) (i))
Vehicles internal headlight adjuster altered to recheck lights ()
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 155/65/14 (5.2.3 (d) (i))
Offside Front Position lamp not working (4.2.1 (a) (ii))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill area (5.3.6 (a) (i))
Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))
Stop lamp(s) remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS
Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Exhaust corroded
Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))
Front Coil spring corroded Both, lower sections (5.3.1 (b) (i))
Front Headlamp lens slightly defective Both, slightly misted (4.1.1 (b) (i))
Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))
Front Registration plate deteriorated but not likely to be misread (0.1 (b))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Rear Coil spring corroded Both (5.3.1 (b) (i))
Rear axle corroded
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Brake pipe corroded, covered in grease or other material front to rear (at rear end) (1.1.11 (c))
Nearside Front Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))
Exhaust system insecure centre mounting snapped (6.1.2 (a))
Front Windscreen washer not working (3.5 (a))
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Brake pipe corroded, covered in grease or other material front to rear (at rear end) (1.1.11 (c))
Nearside Front Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Offside Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))
Tyre slightly damaged/cracking or perishing both front (5.2.3 (d) (ii))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Exhaust has a major leak of exhaust gases (6.1.2 (a))
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))
Offside Brake pipe excessively corroded front to rear (1.1.11 (c))
Windscreen washer not working (3.5 (a))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Offside Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))
Tyre slightly damaged/cracking or perishing both front (5.2.3 (d) (ii))
Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))
Nearside Rear Service brake excessively binding (1.2.1 (f))
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))
Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Exhaust has a major leak of exhaust gases (6.1.2 (a))
Front Brake pad(s) wearing thin (3.5.1g)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)
Offside rear brake application uneven (3.7.B.2)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Front Brake pad(s) wearing thin (3.5.1g)
Front Windscreen wiper does not clear the windscreen effectively (8.2.2)
Under-trays fitted obscuring some underside components
Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS
How Reliable is the Toyota Aygo?
Based on 3,073,569 MOT tests across 286,185 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
YG58 BPV is a 2008 Toyota Aygo in Silver with a 998cc petrol engine. This vehicle has been through 26 MOT tests with a personal pass rate of 61.5%.
Across all 2008 Toyota Aygo models, the average MOT pass rate is 74.7% with a typical mileage of 54,541 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Toyota Aygo fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 33,372 recorded failures. If you're considering buying YG58 BPV, it's worth having these areas checked by a mechanic before committing.
The Toyota Aygo typically stays on UK roads for around 21 years. At 18 years old, this Toyota Aygo is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of YG58 BPV?
You can check the full history of YG58 BPV by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was YG58 BPV registered?
YG58 BPV is a 2008 Toyota Aygo, first registered on 1 September 2008.
Is YG58 BPV safe to buy?
The MOT history for YG58 BPV shows 26 tests with a 61.5% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does YG58 BPV have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on YG58 BPV. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.