2008 Mazda 3

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

exhaust pipe and hangers corroded

heat shield loose

n/s sill pushed in

sump corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 205/55 r16 91v (5.2.3 (d) (i))

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure outer sidewall (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

exhaust pipe and hangers corroded

heat shield loose

n/s sill pushed in

sump corroded

surface corrosion on underside of car

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

offside parking brake effort low

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement inner (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement inner (2.4.G.2)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear rear parking (secondary) brakes imbalanced (3.7.B.6b)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)