2003 Mercedes-benz Vito

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Exhaust emissions test aborted because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Nearside Front Body has an unsafe modification sharp edges (6.2.1 (d) (i))

Nearside Front Road wheel badly distorted (5.2.2 (c) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point (5.3.6 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Body has an unsafe modification sharp edges (6.2.1 (d) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point (5.3.6 (a) (i))

Offside Rear fog lamp lens defective such that emitted light is adversely affected (4.5.1 (b) (ii))

Nearside Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Offside Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

tap on engine

underbody heavily undersealed around repair but found to be solid

Front passenger door cannot be opened from inside the vehicle (6.2.B.1b)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part insecure (3.6.B.4a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Side repeater not working (1.4.A.2c)

Parking brake: efficiency below requirements (3.7.B.7)

tap on engine

Front passenger door cannot be opened from inside the vehicle (6.2.B.1b)

Nearside Front Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Nearside Side repeater incorrect colour (1.4.A.2f)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner/outer sill (2.4.A.3)

Offside Side repeater incorrect colour (1.4.A.2f)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

general underbody condition poor

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Side repeater incorrect colour (1.4.A.2f)

Nearside Stop lamp not working (1.2.1b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

Offside Side repeater incorrect colour (1.4.A.2f)

Offside Stop lamp not working (1.2.1b)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

mirrors cracked but not seriously affecting drivers view

mirrors cracked but not seriously affecting drivers view

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Registration plate lamp not working (1.1.5c)

Shock absorber has a light misting of oil (2.7.3)

low effort near side rear park brake

small stone chips in wind screen

wiper blades starting to split

Registration plate lamp not working (1.1.C.1d)

Shock absorber has a light misting of oil (2.7.3)

low effort near side rear park brake

small stone chips in wind screen

wiper blades starting to split