2006 BMW 535

Front Exhaust has a minor leak of exhaust gases flexible section (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Exhaust has a minor leak of exhaust gases flexible section (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Headlamp aim too high both (4.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside rear subframe mounting points (5.3.6 (a) (i))

plastic undershields fitted to underside off vehicle

Nearside Front Position lamp not working (4.2.1 (a))

Rear Brake pipe excessively corroded crosspipe (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside rear subframe mounting points (5.3.6 (a) (i))

plastic undershields fitted to underside off vehicle

covers and shields fitted

Fuel tank leaking (7.2.3)

covers and shields fitted

Handbrake just made effiencey

Nearside Front coil spring broken (2.4.C.1a)

Offside Front coil spring broken (2.4.C.1a)

Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Handbrake just made effiencey

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Outer Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)