2006 Mazda 2

Front subframe is corroded

both rear axle bushes are slightly worn

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front subframe is corroded

Front wiper linkage is worn

N/s/f and o/s/f tyre are worn low on inner edges

both rear axle bushes are slightly worn

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake pipe slightly corroded Both x2 front to rear brake pipes are corroded (3.6.B.2c)

N/s/f and o/s/f indicator bulbs are flashing slightly white

Nearside Front wheel bearing has slight play

Offside Front brake pipe is bent

exhaust and rear suspension springs are corroded

Exhaust system has corrosion but still secure

Nearside Brake pipe slightly corroded front to rear @ rear (3.6.B.2c)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Brake pipe slightly corroded Front to rear @ rear (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Nearside Rear wheel bearing rough when rotated (2.6.1) DANGEROUS

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)

Front Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Nearside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)