2008 BMW Z4

Front Brake hose slightly deteriorated both (1.1.12 (b) (ii))

edge wear on both rear tyres(inner edges),uneven wear and cuts in both front tyres

offside front top strut mount unbonding..handbrake travel becoming high

oil leaks

play in offside steering arm joint,front inner roll bar bushes

Front Brake hose slightly deteriorated both (1.1.12 (b) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

edge wear on both rear tyres(inner edges),uneven wear and cuts in both front tyres

offside front top strut mount unbonding..handbrake travel becoming high

oil leaks

play in offside steering arm joint,front inner roll bar bushes

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords Outer sidewall (5.2.3 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake servo defective or ineffective Air leak from servo or component (1.1.10 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure Outer sidewall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords Outer sidewall (5.2.3 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front brake not quite as free as the o/s/f

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Undertray not fully secure (8.1.1 (b) (i))

rather a lot of heat has been used to try and move the tracking adjusters

Exhaust mounting defective Rear exhaust box mounting bracket corroded (6.1.2 (a))

Nearside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear coil spring broken (2.4.C.1a) DANGEROUS

Offside Rear coil spring broken (2.4.C.1a) DANGEROUS

Nearside Front Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Engine covers fitted obscuring some components in the engine bay

Front Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components

Under-trays fitted obscuring some underside components