2009 Fiat Grande Punto

Front Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Front Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

existing repairs to offside outer sill untidy but appear ok

handbrake lazy both rears

poor image both headlamps

Front Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Front Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

existing repairs to offside outer sill untidy but appear ok

handbrake lazy both rears

poor image both headlamps

Stop lamp(s) all not working (4.3.1 (a) (iii))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords outer wall split (5.2.3 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Central Undertray not fully secure (8.1.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

poor image both headlamps

rear springs getting corroded

rear undersills and chassis rails getting corroded

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Position lamp missing (4.2.1 (a) (ii))

Offside Position lamp missing (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Service brake binding but not excessively (1.2.1 (f))

Nearside Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit Small cuts (4.1.E.1)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Offside rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. Not locking, low effort. (3.7.B.6b)

exhaust corroding

front wipers splitting

slight lip front discs

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

exhaust corroding

front wipers splitting

slight lip front discs

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Shock absorber has a light misting of oil (2.7.3)

exhaust corroding

Offside Front Shock absorber has a light misting of oil (2.7.3)

exhaust corroding not yet weak or blowing