2011 Mitsubishi Lancer

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Brake pad(s) wearing thin close to 1.5mm (1.1.13 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Brake pad(s) wearing thin close to 1.5mm (1.1.13 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps x2. (4.7.1 (b) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill. (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill. (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Sub-frame corroded but not seriously weakened front and rear (5.3.3 (b) (i))

multiple suspension components corroded on front and rear

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

emissions limit is 0.70

Exhaust emissions test aborted because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

emissions limit is 0.70

Windscreen has damage to an area less than a 40mm circle outside zone 'A' chip (8.3.1d)

Exhaust emits an excessive level of metered smoke (7.4.B.3a)

Offside Front position lamp(s) not working (1.1.A.3b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' sat holder (8.3.1e)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' chip (8.3.1d)

Items removed from driver's view prior to test

Nail in nearside rear tyre

Under-trays fitted obscuring some underside components

both rear tyres worn thin on inner tread section

exhaust heat shield adrift

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)