2013 Citroen C3

Nearside Front Road wheel slightly distorted outer bead rim dented. (5.2.2 (c) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Central Front Exhaust has a major leak of exhaust gases flexi section of exhaust holed and has a major leak of gases . (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits due to holed exhaust flexi section . (8.2.1.2 (c))

Nearside Front Anti-roll bar linkage ball joint excessively worn drop link worn . (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt cv boot holed and leaking grease . (6.1.7 (g) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm 185/65x15 (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm 185/65x15 . (5.2.3 (e)) DANGEROUS

Nearside Front Outer Drive shaft joint worn, but not excessively outer cv joint noisy when entering mot bay . (6.1.7 (c) (i))

Nearside Front Road wheel slightly distorted outer bead rim dented. (5.2.2 (c) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits lambda high due to blowing exhaust rear silencer . (8.2.1.2 (c))

Nearside Front Anti-roll bar linkage ball joint excessively worn drop link worn . (5.3.4 (a) (i))

Nearside Front Bumper insecure corner damaged and insecure . (6.1.4 (a) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect bulb position incorrect . (4.1.2 (c))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt cv boot insecure - clip missing . (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Parking brake inoperative on one side low performance . (1.4.1 (a))

Offside Rear Exhaust has a major leak of exhaust gases exhaust silencer holed and has a major leak of gases . (6.1.2 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm 185/65x15 (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm 185/65x15 (5.2.3 (e)) DANGEROUS

Engine MIL inoperative or indicates a malfunction malfunction - lamp on constantly. (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases leaking from around catalyst area - may be catalyst itself or gasket. (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm 185/65x15 under 1.6 mm (5.2.3 (e)) DANGEROUS

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust system insecure Both mountings (6.1.2 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Exhaust mounting defective (6.1.2 (a))

Advise rear most exhaust support is very deteriorated

Advise rear most exhaust support is very deteriorated

Offside Front Headlamp not working on dipped beam (1.7.5a)

Rear Exhaust system not adequately supported 2nd rear most support on exhaust (7.1.1)

rear exhaust silencer hanger corroded