2003 MG Zr

Brake disc worn, but not excessively O/s And N/s Front (1.1.14 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened O/s And N/s Rear (1.1.14 (a) (ii))

Brake pedal wearing smooth (1.1.2 (c))

Exhaust Corroded At Welds

Front Suspension Soft

Suspension component mounting prescribed area is corroded but not considered excessive Outer Sills At Rear Slightly Corroded (5.3.6 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Passenger seat(s) missing at time of test ()

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Passenger seat(s) missing at time of test ()

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Rear Exhaust emissions likely to be affected by an exhaust leak REAR BRACKET (8.2.1.1 (b))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Both front brake discs corroded

Nearside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Emissions not tested (7.0)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

engine over heating

n/s/r tyre perished

o/s/f abs ring cracked

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

both rear tyres perishing

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

both rear tyres perishing

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Exhaust has part of the system slightly deteriorated (7.1.1a)

small cut in near side front tyre side wall

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)