2008 Mazda 6

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement most rear (5.3.4 (a) (i))

Nearside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement most rear (5.3.4 (a) (i))

bonnet lever insecure

Headlamp aim not tested o/s and n/s (4.1.2 (b))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened o/s and n/s (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive o/s and n/s chasis (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Service brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Windscreen wiper does not clear the windscreen effectively Both (3.4 (b) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Service brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front tyres wearing on both edges

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Front tyres wearing on both edges

Both inner body sills corroded

Hand brake travel high

Whole exhaust slightly corroded

Battery insecure (1.9.1)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Rear Registration plate lamp not working both sides (1.1.C.1d)

Both inner body sills corroded

Hand brake travel high

Whole exhaust slightly corroded

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nail in nearside rear tyre

Rear Brake pad(s) wearing thin (3.5.1g)