2008 Citroen Xsara

Central Seat belt buckle not functioning as intended (7.1.2 (d))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Obligatory mirror missing (3.3 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively x2 (3.4 (b) (ii))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Track rod end slightly misaligned (2.1.3 (e))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Driver's airbag obviously inoperative (7.1.5 (c))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Front Coil spring mounting insecure to the extent that relative movement is visible both fouling inner wing (5.3.1 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Power steering component(s) has slight seepage from a component (2.3.3b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Exhaust system not adequately supported (7.1.1)

Power steering component(s) has slight seepage from a component (2.3.3b)