2008 Subaru Forester

general underbody corrosion

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

general underbody corrosion

Fluid leak, but not excessive coolant (8.4.1 (a) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Upper Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength by shock mount (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Upper Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Fluid leak, but not excessive coolant (8.4.1 (a) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pad(s) wearing thin 2 mm close to limit of 1.5 mm (1.1.13 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pad(s) wearing thin 2 mm close to limit of 1.5 mm (1.1.13 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Suspension component mounting prescribed area is corroded but not considered excessive Both rear (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge Both rear (5.2.3 (e))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Brake pipe excessively corroded to rear from rear joint (1.1.11 (c))

Offside Front Brake pipe excessively corroded to rear from joint (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake pipe corroded, covered in grease or other material front to rear at rear junction (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged and affecting the driver's view of the road (3.2 (a) (ii))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Exhaust has a minor leak of exhaust gases (7.1.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)