2009 Toyota Auris

All Four Brake Discs Corroded

Brake pipe corroded, covered in grease or other material Both Side Rear (1.1.11 (c))

Front + Rear Suspensions Has Corrosion From Underneath

Macpherson strut corroded but not seriously weakened Both Front Shocker (5.3.3 (b) (i))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Rear bumper damage

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear axle corroded

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Brake pipe corroded, covered in grease or other material Both Side Rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Water in Light

Front Suspension arm pin or bush worn but not resulting in excessive movement offside/nearside (both) (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced offside/nearside (both) (6.1.1 (c) (i))

Offside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

underbody corrosion

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a))

Offside Front Position lamp not working (4.2.1 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nail in nearside rear tyre

Nearside Headlamp aim too low and too far to the right. (1.8)

Rear Brake pad(s) wearing thin (3.5.1g)

water in nsr lamp unit

Rear Brake pad(s) wearing thin (3.5.1g)

water in nsr lamp unit