2003 Fiat Doblo

Offside Rear Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner outer sill (6.2.2 (d) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arms corroded

Nearside Non obligatory mirror damaged ()

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outersills (6.2.2 (d) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting innersill (6.2.2 (d) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arms corroded

Nearside Non obligatory mirror damaged ()

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outersills (6.2.2 (d) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced innersills (6.1.1 (c) (i))

both side wishbone slightly corroded

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Brake load sensing valve stiff (3.6.E.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

both side wishbone slightly corroded

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Vehicle structure has slight corrosion (6.1.B.2)

engine management light on

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp aim too high (1.8)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear passenger door cannot be opened from outside the vehicle (6.2.B.1c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Vehicle structure has slight corrosion (6.1.B.2)

engine management light on

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

o/s/f brake pipe slighty croded

rear brake pipes covered with plastic cover

Front front brake application uneven (3.7.B.2)

Rear Registration plate lamp not working (1.1.5c)

Rear rear brake application uneven (3.7.B.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

o/s/f brake pipe slighty croded

rear brake pipes covered with plastic cover

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)