2003 Fiat Ducato

Offside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Exhaust mounting defective (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive under wheel arch (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Suspension component mounting prescribed area is corroded but not considered excessive underside of vehicle (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Brake pipe leaking on a hydraulic braking system to flex (1.1.11 (b) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Exhaust mounting defective (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive under wheel arch (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Suspension component mounting prescribed area is corroded but not considered excessive underside of vehicle (5.3.6 (a) (i))

Exhaust system insecure rubber mounting broken x2 (6.1.2 (a))

Horn not working (7.7 (a))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wing (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassie (6.1.1 (c) (i))

Nearside Rear Upper Position lamp not working (4.2.1 (a) (ii))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassie (6.1.1 (c) (i))

Offside Front Position lamp not working headlamp out (4.2.1 (a) (ii))

Offside Front Position lamp not working mainbeam out (4.2.1 (a) (ii))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Integral body structure has excessive corrosion which adversely affects braking or steering chrossmember (6.1.1 (c) (ii)) DANGEROUS

Nearside Front Integral body structure has excessive corrosion which adversely affects braking or steering subframe mounting (6.1.1 (c) (ii)) DANGEROUS

Offside Front Integral body structure has excessive corrosion which adversely affects braking or steering subframe mounting (6.1.1 (c) (ii)) DANGEROUS

Brake lever not releasing correctly and functionality of brakes affected seized and travel (1.1.2 (b) (ii))

Brake pedal not releasing correctly and functionality of brakes affected (1.1.2 (b) (ii))

Brake performance not tested excess footbrake travel (1.2.1 (g))

Central Front Registration plate does not conform to the specified requirements faided (0.1 (d))

Exhaust emissions likely to be affected by an induction leak not tested (8.2.2.1 (b))

Exhaust system insecure rubber mountings missing (6.1.2 (a))

Nearside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced arch corroded and filled (6.1.1 (c) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassie filled and not welded (6.1.1 (c) (i))

Nearside Rear Upper Position lamp not working (4.2.1 (a) (ii))

Offside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced wing filled and welded (6.1.1 (c) (i))

Offside Rear Upper Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust emissions likely to be affected by an exhaust leak pipe (8.2.1.1 (b))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner door step (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis out rigger (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner door step (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis out rigger (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (5.3.6 (a) (i))

Play in steering rack inner joint(s)

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner door step (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis out rigger (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner door step (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis out rigger (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (5.3.6 (a) (i))

Play in steering rack inner joint(s)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive chassie (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive chassie (2.4.A.3)

Nearside rear upper side marker lamp not working

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside rear upper side marker lamp not working

n/s/r tyre wall cracking

Items removed from driver's view prior to test

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Rear Exhaust mounting missing (7.1.1b)

Exhaust system not adequately supported (7.1.1)

Nearside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)