2008 Honda Accord

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Nail in tyre ()

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

nearside steering gaiter damaged

rear brake pads wearing thin

Both rear wheel bearings feel slightly rough

Front registration plate deteriorated (6.3.1d)

Nearside Steering rack gaiter split (2.2.D.2d)

Both rear wheel bearings feel slightly rough

Offside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)