2010 Iveco Daily 35S14 LWB

General surface corrosion to underside of vehicle.

Nearside Front Corrosion within 30cm of a body mounting, body still secure.

Offside Rear Nail in tyre Not repairable, puncture in shoulder. ()

Horn not working (7.7 (a))

Nearside Obligatory mirror seriously damaged, affecting the rear view (3.3 (b) (ii))

Nearside Side repeater incorrect colour (4.4.3 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

General surface corrosion to underside of vehicle.

Nearside Front Corrosion within 30cm of a body mounting, body still secure.

Offside Rear Nail in tyre Not repairable, puncture in shoulder. ()

Brake pipe corroded, covered in grease or other material PLASTICK COVERED AREAS SWOLLEN (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive FRONT SUBFRAME AND WISHBONES .. MONITOR (5.3.6 (a) (i))

Tyre has a cut but not deep enough to reach the ply or cords N/S/F (5.2.3 (d) (i))

Tyre worn close to legal limit/worn on edge O/S/R + SIDEWALL HEAVILY SCUFFED (5.2.3 (e))

Outline marker lamp missing N/S CENTRE BROKEN (4.2.1 (a) (ii))

Outline marker lamp not working O/S SIDE, FRONT (4.2.1 (a) (ii))

Rear fog lamp not working O/S (4.5.1 (a) (ii))

Stop lamp(s) not working O/S (4.3.1 (a) (ii))

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords N/S/R (5.2.3 (d) (i))

Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected FRONT SUBFRAME AJACENT TO WISHBONE FIXING (5.3.6 (a) (ii)) DANGEROUS

Tyre has a bulge, caused by separation or partial failure of its structure N/S/F OUTER SIDEWALL (5.2.3 (d) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material PLASTICK COVERED AREAS SWOLLEN (1.1.11 (c))

Headlamp aim too high BORTH RESET TO 850mm LEVEL (DIAL ZEROED) (4.1.2 (a))

Suspension component mounting prescribed area is corroded but not considered excessive FRONT SUBFRAME AND WISHBONES .. MONITOR (5.3.6 (a) (i))

Tyre has a cut but not deep enough to reach the ply or cords N/S/F (5.2.3 (d) (i))

Tyre worn close to legal limit/worn on edge O/S/R + SIDEWALL HEAVILY SCUFFED (5.2.3 (e))

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded bulk head and inner wing area (1.1.21 (e) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Prop shaft bearing excessively worn both (6.1.7 (b) (i))

Rear Anti-roll bar pin or bush excessively worn nearside and offside D bushes (5.3.4 (a) (i))

Brake master cylinder/servo mounting prescribed area is excessively corroded (1.1.21 (e) (i))

Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

All direction indicators incorrect colour some bulbs (4.4.3 (a))

Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected o/s and n/s frontcross member (5.3.6 (a) (ii)) DANGEROUS

rear parking brake cables corroding

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Horn not working (1.6.2a)

Offside Side repeater incorrect colour (1.4.A.2f)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Trailer electrical socket insecure (1.9.3a)

All position lamps not working (1.1.A.3b)

Nearside Rear Rear position lamp(s) incorrect colour (1.1.A.3e)

Nail in nearside rear tyre

slight play in n/s/r and o/s/r roll bar bushes