2005 Yamaha Ybr

Clutch lever bent (6.2.7 (b))

Exhaust noisy after market (8.1.1 (a))

Rear Brake lining(s) close to minimum limit Needs new , boarder line pass (1.1.13 (a))

Clutch lever bent (6.2.7 (b))

Exhaust noisy after market (8.1.1 (a))

Headlamp aim too low set (4.1.2 (a))

Rear Brake lining(s) close to minimum limit Needs new , boarder line pass (1.1.13 (a))

Drive chain excessively tight (6.1.7 (k) (i))

Front Headlamp aim too high (4.1.2 (a))

All direction indicators adversely affected by the operation of another lamp indicators are incorrectly wired (4.4.3 (b))

Brake grabbing severely Once pushed sticks on but brake is not efficient (1.2.1 (c))

Nearside Rear All direction indicators light intensity significantly reduced covered with tape (4.4.3 (a))

Nearside Rear Brake pedal has insufficient reserve travel (1.1.2 (a))

Offside Front Brake lever has insufficient reserve travel very spongy (1.1.2 (a))

Rear Brake effort inadequate at a wheel drum shaft sized (1.2.1 (a) (i))

Stop lamp not working (4.3.1 (a) (ii))

Front Brake pad(s) close to minimum limit end of life, require replacement (1.1.13 (a))

Rear Brake lining(s) close to minimum limit end of life, (1.1.13 (a))

Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Rear Tyre incorrectly seated on the wheel rim (5.2.3 (k))

Rear Wheel alignment incorrect which adversely affects the handling (2.4 (a))

Rear Drive chain slightly loose (6.2.1d)

Rear Drive chain sprocket carrier worn but not considered excessive cush drive rubbers slightle worn (6.2.1e)

Nearside Rear shock absorber has a light misting (2.4.A.1c)

Rear Drive chain slightly tight (6.2.1d)

Front Front mudguard insecure (2.3.7)

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Drive chain slightly loose (6.2.1d)

Front suspension has a slightly reduced damping effect (2.3.6c)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Offside Front suspension assembly has slight free play between the sliding members (2.3.4)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Brake disc(s) slightly worn (3.2.A1l)